有时候双组份打胶机打出的胶体可能出现混合不均匀的现象，影响着产品的质量！下面双组份打胶机厂家的小编就给大家介绍一下造成结构胶混合不均匀的原因！
Sometimes the colloid produced by the two-component glue beater may appear uneven mixing phenomenon, affecting the quality of the product! The following two-component glue maker's small edition will introduce to you the causes of uneven mixing of structural glue!
混合不均匀的结构胶有以下四种情况及原因如下：
There are four kinds of uneven mixing structural adhesives and the reasons are as follows:
①连续花胶：一般是混合器堵塞、混合器装配错误或者使用的混合单元不够多;
(1) Continuous gum: generally, the mixer is blocked, the mixer assembly is wrong or the mixing unit is not enough;
②断续有规律花胶：与系统性故障有关，如配比泵密封泄漏或者比例架磨损;
(2) Intermittent regular pattern gum: related to systemic faults, such as leakage of seal of proportioning pump or wear of proportioning frame;

③断续无规律花胶：与故障有关，如过滤器堵塞/针阀堵塞/压盘故障/配比泵入口堵塞或者密封失效/阀及高压球阀失效等;
(3) Discontinuous irregular pattern gum: related to faults, such as filter blockage/needle valve blockage/platen failure/ratio pump entrance blockage or seal failure/safety valve and high pressure ball valve failure;
④短暂停枪后又开枪时，开头出现一段花胶：主要是胶粘度匹配不理想，需要调整系统管道或降低工作压力。
(4) When the gun stops for a short time and fires again, a section of gum appears at the beginning: the main reason is that the gum viscosity matching is not ideal, and the system pipeline needs to be adjusted or the working pressure should be reduced.
今天的精彩内容就暂且给大家介绍到这里了，欢迎大家百度搜索：双组份打胶机，这样可以找到我们，我们会定期发布更多的相关资讯，大家也可以直接收藏我们的官网：http://linshi.jncsjx.com！谢谢大家长久以来的支持！
Today's wonderful content will be introduced here for the time being. Welcome to Baidu Search: Two-component glue machine, so that we can find us, we will regularly release more relevant information, you can also directly collect our official website: http://linshi.jncsjx.com! Thank you for your long-standing support!