日常运用进程中，要留意打胶机的颐养维护
In the process of daily use, we should pay attention to the maintenance of gluing machine.
1、机头密封圈在7-10天需求改换一次;
1. Head sealing ring should be changed once in 7-10 days.
2、改换时一切部位都要清洗洁净，不能有原料残留;
2. When changing, all parts should be cleaned and cleaned, and there should be no residue of raw materials.
3、每天上班前将久耐混合管取下，钢钩取下，将机头清算洁净。将B料孔和挂钢钩的孔位打好黄油，并将B料孔封住，以免B料固化。混合管也要清洗洁净，保证静态胶阀A/B出胶口没有残胶。机身外表清算洁净，保证机器清洁。
3. Take off the durable mixing pipe and the steel hook before going to work everyday, and clean the nose. Butter is drilled in the hole position of B material hole and hook, and B material hole is sealed to avoid solidification of B material. The mixing pipe should also be cleaned to ensure that the static rubber valve A/B outlet has no residual glue. Clean fuselage exterior to ensure machine cleaning.

4、开机前迟缓装上钢钩，新的钢钩顶部用砂纸打磨一下，让其圆润润滑，要装到位，察看机头马达能否能正常运转?出料气缸能否能正常运作?
4. Install the steel hook slowly before starting the machine. Sand paper is used to polish the top of the new steel hook to make it smooth and lubricated. To be installed in place, check whether the motor of the machine head can work properly and whether the discharging cylinder can work properly.
5、正常消费前记得排出一小局部胶料，由于外面能够有黄油残留，排出以免影响产质量量。
5. Before normal consumption, remember to discharge a small amount of rubber, because there can be butter residue outside, discharge to avoid affecting the quality of production.
6、每个月需求清算一次气源过滤器，和下胶管Y型过滤器。一切运动局部反省能否有松动，并加光滑油。假如长工夫机器停用，清算机器外面一切料桶与料管的胶水。并要清算完一切管道的清洗液。
6. Air source filters and Y-type Downhose filters are required to be cleared once a month. Reflect on the looseness and smoothness of all movements. If the long-time machine is out of use, the glue of all barrels and pipes outside the machine is cleared. Cleaning fluids for all pipes should also be cleared.
更多的关于双组份打胶机问题或者详细的内容，请关注我们济南昌盛机械的网站：//www.qianyantong-e.com谢谢!!
For more information about the two-component glue machine, please pay attention to our website of Changsheng Machinery in Jinan: //www.qianyantong-e.com, thank you!