1、中空玻璃双组份打胶机必需在无灰尘、无溶剂污染、温度相宜的环境中出产,出产车间灰尘污染会对中空玻璃密封系统各个构件的粘接效果产生很大的不利影响,粘接效果不好的中空玻璃制品其密封机能和功能寿命，

1, hollow glass glue machine must be produced in no dust, no solvent pollution, temperature appropriate environment, has influenced the production workshop dust pollution on the bonding effect of hollow glass sealing system of various components, insulating glass bonding effect is not good the sealing function and function of life,

2、 如果中空玻璃打胶机不够光滑需要经设备打磨，直到出胶正常为止。丁基胶在生产中不粘中空玻璃，通常原因是铝条涂完丁基胶时间过长，造成丁基胶表面冷却，或者是玻璃边缘有水气。建议涂完丁基胶要尽快合片，和调整清洗机使玻璃边缘彻底干燥。

2, if the insulating glass polishing machine is not smooth enough, need to be polished by equipment until the glue is normal. The non stick insulating glass in the production of butyl rubber is usually due to the excessive time of the end of the butyl coating on the aluminum strip, or the cooling of the butyl rubber surface or the water vapor at the edge of the glass. It is recommended to apply butyl rubber as soon as possible and adjust the washer so that the glass edge is thoroughly dried.

3、因为溶剂的存在会导致丁基胶失去粘接力,从而使道密封失败.因此,车间不要使用挥发性物质,且保持空气通畅.

3 because the presence of solvents will lead to the loss of adhesion of butyl rubber, so that the first seal failed. Therefore, the workshop should not use volatile substances, and keep the air clear

适合的温度是二道密封形成有效结果的必要前提,第二道密封胶供胶温度应尽量保证在10℃以上,只有相宜的温度才能让密封胶在划定的时间内达到使用效果,好比初始粘接力、剪切强度、弹性模量、密封机能等.

Suitable temperature is a necessary prerequisite for two seals to form an effective result, second sealant glue temperature should be kept above 10 DEG C, the temperature can only make appropriate sealant to achieve results within a specified time, such as initial adhesion, shear strength, elastic modulus, sealing performance and so on.

本文的精彩内容来自双组份打胶机详细内容请点击我们的网站://www.qianyantong-e.com/谢谢您的到来!

The exciting content of this article comes from the two component dispenser, please click on our official website: //www.qianyantong-e.com/, thank you for coming!